How to JTAG IbootCore into your K1:

(Last edited 2003-03-18 by AALacl)

WARNING: This will destroy whatever else you have in the flashes on your MMI 
board !

Use a Lauterbach JTAG pod for OMAP1510

Edit these -.cmm files to match your PC setup (set up the correct paths).

Open T32 and connect the JTAG connector to the MMI debug board (pin 1 is in the left hand side of the connector).

Switch on the mobile and run the 1510.cmm setup file. Must run without errors - you may have to try several times ! (Easier if you use the ignition switch on a Bootadapter 2000 box !)

Run FlashIbootCore_5.cmm (takes about 6 min.). Must run without errors !

Next time you switch on the mobile, it will start up the IbootCore, if you keep the center key depressed during the start up ! (Or in RFT testmode, if you pull TP3008 hi during the start up !)   